Rohde & Schwarz SMBV100B - How to Save and Recall Instrument Settings

File and Data Management
R&S
®
SMBV100B
485User Manual 1178.4460.02 ─ 03
Remote command:
*RCL on page 613
File Manager
Accesses the "File Manager" dialog, see Chapter 9.8, "Using the File Manager",
on page 491.
9.4.2 How to Save and Recall Instrument Settings
Instrument settings can be saved to a file and loaded again later, so that you can
repeat the tests with the same settings.
Accessing and recalling instrument setups
For quick access to a stored instrument setup, assign the appropriate action to the [★
(User)] key.
See Chapter 10.3.3, "Assigning Actions to the [★ (User)] Key", on page 529.
To save and recall instrument settings quickly
1. Select Save/Rcl > "Operation Mode > Save".
2. Select "Save Immediate 1".
The instrument saves its settings in the intermediate memory 1. The filename and
the storage location cannot be changed.
3. Adapt the instrument settings as required. Select "Save Immediate 2"
4. To restore the settings, select the "Operation Mode > Recall"
5. Select "Recall Immediate 1"
The instrument is restored to the previous state.
6. Select "Recall Immediate 2" to switch to the settings stored in the second file.
To save complete instrument settings
1. Select Save/Rcl > "Operation Mode > Save".
2. In the file selection dialog, select a filename and storage location for the settings
file.
3. Select "Save".
A file with the defined name and path and the extension *.savrcltxt is created.
To restore instrument's configuration
Save the configuration as described in "To save complete instrument settings"
on page 485.
1. To restore settings, select Save/Rcl > "Operation Mode > Recall".
Saving and Recalling Instrument Settings