Rohde & Schwarz SMBV100B - Remote Config Settings

Multi-Instrument Setups
R&S
®
SMBV100B
450User Manual 1178.4460.02 ─ 03
Settings:
Remote Config Settings.............................................................................................. 450
Remote Control Settings.............................................................................................453
Show Connector..........................................................................................................454
Remote Config Settings
Access:
► Select "Taskbar > System Config > System Configuration > External RF and I/Q >
External Instruments > Config ...".
Settings:
Detect/Scan.................................................................................................................450
Clean Unused/Clean All..............................................................................................451
External Instrument.....................................................................................................451
Set Symbolic Name.....................................................................................................451
Remote Channel......................................................................................................... 451
Name / IP Address......................................................................................................452
RF Path.......................................................................................................................452
Initialization Sequence................................................................................................ 452
Remove Initialization Sequence..................................................................................452
Apply........................................................................................................................... 452
Apply and Connect......................................................................................................452
Detect/Scan
If you connect an external instrument, you can fill in the required information in the
"External Instrument Configuration" dialog manually or use one of the provided "Detect/
Scan" functions. Both functions consider the connections via the supported interfaces,
USB or LAN.
The parameter External Instrument lists the pool of available instruments.
Scans the network for connected supported instruments, like:
R&S SGS or R&S SGT.
Note: The scan function searches throughout the entire network and can last several
minutes.
Note: The first initialization of an instrument connected to a network can last several
minutes. During their initialization, instruments are not detected by the detect/scan
function.
"Detect"
Searches for external instruments connected to this particular digital
interface of the R&S SMBV100B.
Remote command:
:SCONfiguration:EXTernal:DIGital:REMote:DETect? on page 673
System Configuration Settings