Rohde & Schwarz SMBV100B - Source:power Subsystem

Remote Control Commands
R&S
®
SMBV100B
867User Manual 1178.4460.02 ─ 03
Example: See Example "Programming Example" on page 866.
Usage: Event
Manual operation: See "Reset Delta Phase Display" on page 297
12.16.15 SOURce:POWer Subsystem
The SOURce:POWer subsystem contains the commands for setting the output level,
level control and level correction of the RF signal.
The default units are dBm. To change the units, perform on of the following:
●
Enter the unit after the numerical value
Example: :POW 0.5V
●
Set the unit with the command :UNIT:POWer.
[:SOURce<hw>]:POWer:ALC[:STATe].............................................................................. 867
[:SOURce<hw>]:POWer:ALC:DSENsitivity....................................................................... 868
[:SOURce<hw>]:POWer:ALC:SONCe.............................................................................. 868
[:SOURce<hw>]:POWer:ALC:SLEVel...............................................................................869
[:SOURce<hw>]:POWer:ATTenuation:DIGital....................................................................869
[:SOURce<hw>]:POWer:ATTenuation:RFOFf:MODE......................................................... 869
[:SOURce<hw>]:POWer:EMF:STATe................................................................................870
[:SOURce<hw>]:POWer:LBEHaviour............................................................................... 870
[:SOURce<hw>]:POWer:LIMit[:AMPLitude].......................................................................870
[:SOURce<hw>]:POWer:LMODe..................................................................................... 871
[:SOURce<hw>]:POWer:MANual.....................................................................................871
[:SOURce<hw>]:POWer:MODE.......................................................................................872
[:SOURce<hw>]:POWer:PEP?........................................................................................ 872
[:SOURce<hw>]:POWer:POWer......................................................................................872
[:SOURce<hw>]:POWer:STARt....................................................................................... 873
[:SOURce<hw>]:POWer:STOP........................................................................................873
[:SOURce<hw>]:POWer:STEP:MODE............................................................................. 873
[:SOURce<hw>]:POWer:STEP[:INCRement].................................................................... 874
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet........................................................ 874
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL............................................................. 875
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]..................................................875
[:SOURce<hw>]:POWer:RANGe:LOWer?........................................................................ 876
[:SOURce<hw>]:POWer:RANGe:UPPer?.........................................................................876
[:SOURce]:POWer:WIGNore...........................................................................................876
[:SOURce<hw>]:POWer:ALC[:STATe] <State>
Activates automatic level control in the selected mode.
Note: The ALC states POW:ALC:STAT OFF and POW:ALC:STAT ONS use a short
sample pulse to set the level control. The level of this sample pulse corresponds to the
sample level setting of the full PEP of the R&S SMBV100B. It does not consider any
signal headroom, e.g. applied to a user-defined ARB waveform.
NOTICE: Risk of DUT damage due to high input power
SOURce Subsystem