Configuring the RF Signal
R&S
®
SMBV100B
297User Manual 1178.4460.02 ─ 03
In the "RF Phase" tab, you can determine the delta phase value and reset the
phase to this reference.
The remote commands required to define the settings are described in Chap-
ter 12.16.14, "SOURce:PHASe Subsystem", on page 866.
Settings
Delta Phase.................................................................................................................297
Reset Delta Phase Display......................................................................................... 297
Delta Phase
Sets the phase of the RF signal.
The current phase of the signal is used as the reference.
Note: Achieving long-term stable phase-locked coupling. We recommend that you use
the LO coupling feature, if you try to synchronize the output signal with the phase of a
second signal generator for example.
See Chapter 6.9, "Local Oscillator Coupling", on page 305.
Remote command:
[:SOURce<hw>]:PHASe on page 866
Reset Delta Phase Display
Adopts the selected "Delta Phase" value as the current value, and resets delta phase
to 0 degrees.
Remote command:
[:SOURce<hw>]:PHASe:REFerence on page 866
RF Phase Settings
To Next Page
Loading...
