Remote Control Commands
R&S
®
SMBV100B
778User Manual 1178.4460.02 ─ 03
Manual operation: See "Marker Mode" on page 159
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
Sets the divider for the pulsed marker signal.
Parameters:
<Divider> integer
Range: 2 to 1024
*RST: 2
Example: See Example "Managing waveform files" on page 738
Manual operation: See "Marker Mode" on page 159
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal. The pulse frequency is
derived by dividing the symbol rate by the divider.
Return values:
<Frequency> float
Increment: 0.001
Example: see Example "Managing waveform files" on page 738
Usage: Query only
Manual operation: See "Marker Mode" on page 159
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay <Delay>
Defines the delay between the signal on the marker outputs and the start of the sig-
nals.
Parameters:
<Delay> float
Range: 0 to depends on other values
Increment: 0.001
*RST: 0
Default unit: Symbol
Example: see Example "Managing waveform files" on page 738
Manual operation: See "Marker x Delay" on page 114
Clock Commands
[:SOURce<hw>]:BB:ARBitrary:CLOCk:SOURce <Source>
Selects the clock source:
●
INTernal: Internal clock reference
SOURce Subsystem
To Next Page
Loading...
