Rohde & Schwarz SMBV100B - Source:bb:impairment Subsystem

Remote Control Commands
R&S
®
SMBV100B
802User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:AWGN:POWer:SUM:PEP?
Queries the peak envelope power of the overall signal comprised of noise signal plus
useful signal.
Return values:
<Pep> float
Range: -145 to 20
Increment: 0.01
*RST: 0
Example: see Example "Generating an additive noise signal" on page 796
Usage: Query only
Manual operation: See "Carrier + Noise PEP, Signal + Noise PEP (Total Band-
width), Carrier + Interferer PEP, Signal + Interferer PEP"
on page 266
[:SOURce<hw>]:AWGN:FREQuency:TARGet <Target>
Sets the desired frequency of the sine wave.
Parameters:
<Target> float
Range: -40E6 to 40E6
Increment: 0.01
*RST: 0
Example: see Example "Generating a CW interferer signal" on page 796
Manual operation: See "Target CW Frequency Offset" on page 261
[:SOURce<hw>]:AWGN:FREQuency:RESult?
Queries the actual frequency of the sine wave.
Return values:
<Result> float
Range: -40E6 to 40E6
Increment: 0.01
*RST: 0
Example: see Example "Generating a CW interferer signal" on page 796
Usage: Query only
Manual operation: See "Resulting CW Frequency Offset" on page 266
12.16.4.6 SOURce:BB:IMPairment Subsystem
This subsystem contains the commands for the analog and digital I/Q impairments.
SOURce Subsystem