Remote Control Commands
R&S
®
SMBV100B
801User Manual 1178.4460.02 ─ 03
Example: see Example "Generating an additive noise signal" on page 796
Manual operation: See "Carrier Power, Signal Power" on page 264
[:SOURce<hw>]:AWGN:POWer:NOISe <Noise>
Sets the power of the noise signal in the system respectively total bandwidth.
Parameters:
<Noise> float
Increment: 0.01
Example: see Example "Generating an additive noise signal" on page 796
Manual operation: See "Noise Power (System Bandwidth), Interferer Power"
on page 265
[:SOURce<hw>]:AWGN:POWer:NOISe:TOTal?
Queries the noise level in the total bandwidth.
Return values:
<Total> float
Range: -145 to 20
Increment: 0.01
*RST: -30
Example: see Example "Generating an additive noise signal" on page 796
Usage: Query only
Manual operation: See "Noise Power (Total Bandwidth)" on page 266
[:SOURce<hw>]:AWGN:POWer:SUM?
Queries the overall power of the noise/interferer signal plus useful signal
Return values:
<Sum> float
Range: -145 to 20
Increment: 0.01
*RST: 0
Example: see Example "Generating an additive noise signal" on page 796
Usage: Query only
Manual operation: See "Carrier + Noise Power, Signal + Noise Power (System
Bandwidth), Carrier + Interferer Power, Signal + Interferer Power
" on page 266
SOURce Subsystem
To Next Page
Loading...
