Rohde & Schwarz SMBV100B - Instrument Emulations Settings

Network Operation and Remote Control
R&S
®
SMBV100B
567User Manual 1178.4460.02 ─ 03
Stop Bits
Sets the number of stop bits for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:SBITs on page 902
11.4.5 Instrument Emulations Settings
Access:
► Select "System Config > Remote Access > Instrument Emulations".
The "Instrument Emulations" dialog enables you to emulate a remote control com-
mand set of another signal generator.
The remote commands required to configure the emulation settings remotely are
described in Chapter 12.17, "SYSTem Subsystem", on page 889.
Language
Selects the instrument whose remote command set is emulated by the
R&S SMBV100B.
Remote command:
:SYSTem:LANGuage on page 905
Mode
Selects the way the instrument identification is performed.
"Automatic"
Sets the "IDN String" and the "OPT String" automatically for the
instrument selected with the parameter Language.
"User Defined"
Enables you to define the "IDN String" and the "OPT String".
Remote command:
:SYSTem:IDENtification on page 903
Remote Access Settings