Rohde & Schwarz SMBV100B - General Settings

Multi-Instrument Setups
R&S
®
SMBV100B
457User Manual 1178.4460.02 ─ 03
In this dialog, you access the settings of both, the Dig I/Q and the HS Dig I/Q
connectors in the same manner. You recognize the type of connector that is active
by the used connector icon.
4. To set the input connector, select "BB Input > General > Interface > HS Dig I/Q"
5. To enable the input signal:
● Select "BB Input > On" or
● Select "BB Input > Baseband Input Settings > State > On".
The internal baseband generator ("Baseband" block) and the external digital baseband
input ("BB Input") cannot be activated simultaneously. They deactivate each other.
The remote commands required to define these settings are described in Chap-
ter 12.16.2, "SOURce:BBIN Subsystem", on page 681.
Settings:
● General Settings................................................................................................... 457
● Signal Input Settings............................................................................................. 459
● Sample Rate Settings........................................................................................... 462
● Input Level Settings...............................................................................................463
8.6.1 General Settings
Access:
► Select "BB Input > Digital I/Q In > Baseband Input Settings".
Digital Baseband Input Settings