Rohde & Schwarz SMBV100B - Carrier Table Settings

Configuring the Internal Baseband Source
R&S
®
SMBV100B
233User Manual 1178.4460.02 ─ 03
3.8.3.2 Carrier Table Settings
Access:
1. Select "Baseband > ARB > General > Multi Carrier".
2. Select "ARB: Multi Carrier > Carrier Table"
This tab comprises the settings of the individual carriers. A selectable carrier range
can be set with the aid of the optional "Carrier Table Assistant".
The settings of all available carriers are displayed in table form. Previously applied
assistant settings can be further refined. The number of lines corresponds to the
number of carriers.
The phase/deg settings are only valid if optimization of the crest factor is disabled
("Crest Factor Mode" = Off).
Use the "Carrier Graph" tab to visualize the selected multi-carrier configuration.
Settings:
Number of Carriers......................................................................................................234
No................................................................................................................................234
State............................................................................................................................234
Carrier Freq [MHz]...................................................................................................... 234
Gain.............................................................................................................................234
Phase..........................................................................................................................234
Delay...........................................................................................................................234
File.............................................................................................................................. 234
Info.............................................................................................................................. 235
!!!................................................................................................................................. 235
Generating Multi-Carrier Signals