Rohde & Schwarz SMBV100B - Clock Settings

Configuring the Internal Baseband Source
R&S
®
SMBV100B
115User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:DELay on page 730
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay on page 778
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay on page 794
3.4.2.3 Clock Settings
Access:
► Select "Baseband > Custom Dig Mod > Clock".
This tab provides access to the settings necessary to select and configure the clock
signal, like the clock source and clock mode.
Settings:
Clock Source............................................................................................................... 115
Clock Source
Selects the clock source.
●
"Internal"
The instrument uses its internal clock reference.
"Clock Signals" on page 91
Remote command:
[:SOURce<hw>]:BB:DM:CLOCk:SOURce on page 730
[:SOURce<hw>]:BB:ARBitrary:CLOCk:SOURce on page 778
[:SOURce<hw>]:BB:MCCW:CLOCk:SOURce on page 795
3.4.2.4 Global Connector Settings
Each of the "Trigger In", "Marker" and "Clock" dialogs as well as the "Trigger Marker
Clock" dialog provides a quick access to the related connector settings.
For more information, refer to the description R&S SMBV100B user manual, section
"Global Connector Settings".
Common Functions and Settings in the Baseband Domain