Rohde & Schwarz SMBV100B - Constant IQ Test Signal

Configuring the Internal Baseband Source
R&S
®
SMBV100B
158User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate on page 749
3.6.3.4 Constant IQ Test Signal
Access:
1. Select "Baseband > ARB > General > Create Test Signal > Const IQ".
2. Select "Create Test Signal".
This dialog provides settings for configuration of a continuous test signal with con-
stant IQ. The I and Q values for each path are adjustable but constant. For more
information, refer to Chapter 3.6.2.2, "ARB Test Signals", on page 147.
Converted to analog, the signal is output directly at the I and Q connectors of the
instrument.
Settings:
I Value, Q Value...........................................................................................................158
Generate Signal File................................................................................................... 158
Generate Signal RAM................................................................................................. 159
I Value, Q Value
Enters the value for the I respectively Q component of the test signal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I on page 746
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q on page 746
Generate Signal File
Generates a signal and saves it as a waveform file on the hard disk. Use the standard
"File Select" function to store this file
Using the Arbitrary Waveform Generator (ARB)