Rohde & Schwarz SMBV100B - Connections Configuration and Connection Status Overview Settings

Multi-Instrument Setups
R&S
®
SMBV100B
445User Manual 1178.4460.02 ─ 03
8.5.2.1 Connections Configuration and Connection Status Overview Settings
Access:
► Select "Taskbar > System Config > System Configuration > External RF and I/Q".
Settings:
Display........................................................................................................................ 445
Auto Connect.............................................................................................................. 445
Connect/Disconnect All Remote................................................................................. 446
Preset behavior: Keep connections to external instruments.......................................446
Connector Name.........................................................................................................446
Direction......................................................................................................................446
External Instrument.....................................................................................................447
I/Q Connection............................................................................................................ 447
Remote Connection Status......................................................................................... 447
Instrument Name.........................................................................................................448
RF Couple...................................................................................................................448
(Delta) RF Frequency/ RF Level................................................................................. 448
RF State......................................................................................................................449
Display
Filters the displayed connectors upon one of the following criteria:
"All Connectors"
No filter is applied.
"Mapped Connectors"
Displayed are only the connectors to which a stream is mapped.
Note: To prevent faults, use this filter before you further configure the
external instruments.
"Input Connectors/Output Connectors"
Filters the display according to connector direction.
Remote command:
:SCONfiguration:EXTernal:DISPlay on page 666
Auto Connect
With enabled auto connect function, the instrument automatically detects connected
external instruments and establishes the required connection.
If the "Auto Connect > Off", however, after a R&S SMBV100B startup you have to
revise the test setup and perform the following:
●
Check whether the necessary connections between the R&S SMBV100B and the
external instruments are still existing.
●
Prove that the remote control of the particular instruments is required.
●
Trigger the Connect All Remote function.
Remote command:
:SCONfiguration:EXTernal:ACONnect on page 666
System Configuration Settings