Rohde & Schwarz SMBV100B - List Editor

Configuring the RF Signal
R&S
®
SMBV100B
341User Manual 1178.4460.02 ─ 03
Select Source/Select ASCII Destination
In "Mode > Export", access the file select dialog that provides standard file handling
functions.
Where:
●
"Select Source": selects the file to be exported
●
"Select ASCII Destination": defines the filename and the file path for the exported
file
Remote command:
[:SOURce<hw>]:LIST:DEXChange:SELect on page 862
[:SOURce<hw>]:CORRection:DEXChange:SELect on page 818
Import / Export
Imports or exports the selected data list file, depending on the current mode.
Remote command:
[:SOURce<hw>]:LIST:DEXChange:EXECute on page 861
[:SOURce<hw>]:CORRection:DEXChange:EXECute on page 817
6.10.7 List Editor
The "User Correction" and "List Mode" dialogs provide a build-in list editor for defining
the corresponding value pairs.
The table and navigation functions of the UCOR and list mode editors have the same
structure and are therefore summarized below. The access is specified for both modes,
the fields and functions are explained using the example of the list mode.
Varying the RF Signal in List or Sweep Mode