Rohde & Schwarz SMBV100B - General Settings

Configuring the RF Signal
R&S
®
SMBV100B
336User Manual 1178.4460.02 ─ 03
The remote commands required to define these settings are described in Chap-
ter 12.16.11, "SOURce:LIST Subsystem", on page 850.
● General Settings................................................................................................... 336
● List Mode Data Settings........................................................................................338
● Import/Export Settings...........................................................................................339
6.10.6.1 General Settings
Access:
► Select "RF" > "Sweep/List" > "List mode > General".
In the "General" tab, you can configure the trigger and dwell time modes for list
processing and activate signal generation.
Settings
State ...........................................................................................................................336
Current Index ............................................................................................................. 336
Mode........................................................................................................................... 337
Dwell Time Mode.........................................................................................................337
Global Dwell Time....................................................................................................... 337
Trigger Slope...............................................................................................................337
Show Connector..........................................................................................................338
Reset ..........................................................................................................................338
Execute Single............................................................................................................ 338
State
Activates the list mode and processes the currently selected list.
Note: Active sweep mode deactivates other sweeps or lists and vice versa.
Remote command:
[:SOURce<hw>]:FREQuency:MODE on page 824
Current Index
Sets the list index for list processing in "Step" mode. In the other modes, the index indi-
cates the current step.
Varying the RF Signal in List or Sweep Mode