Network Operation and Remote Control
R&S
®
SMBV100B
552User Manual 1178.4460.02 ─ 03
Remote device VNC client Requirements Characteristics
Smart device
(Tablet/ smartphone)
●
Dedicated client App
App must be installed. Fast, supports several options like
full screen mode or auto-login.
●
Web browser with HTML5
Web sockets must be supported. Support of QR code scanning
Slower than a dedicated App.
Remote file access (FTP, SAMBA/SMB)
●
A remote client accesses the instrument's file system, using the protocols FTP (file
transfer protocol) and SAMBA/SMB (server message block).
●
The protocols enable you to transfer files from or to the instrument and to get direct
access to its file sharing directory share.
For more information, refer to Chapter 9.9, "How to Transfer Files from and to the
Instrument", on page 497.
11.2 Remote Control Interfaces and Protocols
The instrument supports various interfaces for remote control. The table gives an over-
view on the connectivity:
Table 11-2: Remote control interfaces and protocols
Interface
Protocols, VISA
*)
address string and library
Remarks
Local area network
(LAN)
●
HiSLIP High-Speed LAN Instrument Protocol
(IVI-6.1)
TCPIP::host address::hislip0[::INSTR]
VISA
●
VXI-11
TCPIP::host address[::
LAN device name][::INSTR]
VISA
●
Socket communication (Raw Ethernet, simple
Telnet)
TCPIP::host address[::
LAN device name]::<port>::SOCKET
VISA or socket controller
The LAN connector is on the rear panel of the
instrument.
The interface is based on TCP/IP and supports
various protocols.
For a description of the protocols, refer to:
●
Chapter 11.2.1.2, "HiSLIP Protocol",
on page 555
●
Chapter 11.2.1.3, "VXI-11 Protocol",
on page 555
●
Chapter 11.2.1.4, "Socket Communica-
tion", on page 555
USB
●
USBTMC
USB::<vendor ID>::<product ID>::
<serial number>[::INSTR]
VISA
The USB In connector is located at the rear
panel of the instrument.
For a description of the interface, refer to Chap-
ter 11.2.2, "USB Interface", on page 556
GPIB (IEC/IEEE Bus
Interface)
●
–
GPIB::<address>[::INSTR] (no secondary
address)
VISA
Optional GPIB bus interfaces according to stan-
dard IEC 625.1/IEEE 488.1 are located on the
rear panel of the instrument.
For a description of the interface, refer to Chap-
ter 11.2.3, "GPIB Interface (IEC/IEEE Bus Inter-
face)", on page 557.
*
) VISA (Virtual Instrument Software Architecture) is a standardized software interface library providing input and output functions to
communicate with instruments. A VISA installation on the controller is a prerequisite for remote control over LAN (when using
VXI-11 or HiSLIP protocol), USB and serial interface. For remote control via socket communication VISA installation is optional. For
more information, see Chapter 11.3.1, "VISA Library", on page 558.
Remote Control Interfaces and Protocols
To Next Page
Loading...
