Rohde & Schwarz SMBV100B - Modulation Settings

Configuring the RF Signal
R&S
®
SMBV100B
349User Manual 1178.4460.02 ─ 03
● Press the [Mod on/off] key.
[Mod on/off]
Activate one or more analog modulations and press the [Mod on/off] key to toggle the
state of them all.
Pressing the key again restores the status that was active before the last switch-off.
Remote command:
[:SOURce<hw>]:MODulation[:ALL][:STATe] on page 689
6.11.4 Modulation Settings
Access:
► Select "RF" > "Analog Modulation" > "Modulation Source".
The "Modulation" dialog contains all functions and settings to configure the analog
modulations, the LF signal sources for performing a modulation, and the LF signal
output.
The remote commands required to define these settings are described in:
● Chapter 12.16.3.2, "SOURce:AM Subsystem", on page 689
● Chapter 12.16.3.3, "SOURce:FM Subsystem", on page 694
● Chapter 12.16.3.4, "SOURce:PM Subsystem", on page 699
● Chapter 12.16.3.5, "SOURce:PULM Subsystem", on page 703
● Chapter 12.16.10, "SOURce:LFOutput Subsystem", on page 837
6.11.4.1 Pulse Modulation Settings
Option: see Chapter 6.11.1, "Required Options", on page 346.
Analog Modulations