Rohde & Schwarz SMBV100B - Source State

Configuring the RF Signal
R&S
®
SMBV100B
352User Manual 1178.4460.02 ─ 03
Access:
► Select "RF" > "Analog Modulation" > "Amplitude Modulation/Frequency Modualtion/
Phase Modualtion".
The "FM", "Φ" and "AM" tabs contain the parameters per modulation type.
Source
State............................................................................................................................352
Source.........................................................................................................................353
FM settings..................................................................................................................353
└ Deviation.......................................................................................................353
└ Deviation Mode.............................................................................................353
└ Total Deviation.............................................................................................. 354
└ Ratio Path2/Path1.........................................................................................354
└ Mode.............................................................................................................354
PhiM settings...............................................................................................................354
└ Deviation.......................................................................................................354
└ Deviation Mode.............................................................................................355
└ Total Deviation.............................................................................................. 355
└ Ratio Path2/Path1.........................................................................................355
└ Mode.............................................................................................................355
AM settings................................................................................................................. 356
└ Depth............................................................................................................ 356
└ Sensitivity......................................................................................................356
└ Deviation Mode.............................................................................................356
└ Total Depth....................................................................................................357
└ Ratio Path2/Path1.........................................................................................357
State
Activates a modulation.
Note: Some modulations exclude each other and cannot be performed simultaneously.
For more information, see data sheet.
Analog Modulations