Configuring the Internal Baseband Source
R&S
®
SMBV100B
202User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:COMMent on page 760
Output file
Accesses the standard "File Select" dialog function and requests the filename for the
multi-segment waveform to be calculated.
An output filename is required for further processing of the multi-segment waveform:
●
For the internal storage triggered by the "Save List" function
●
For the calculation and creation of the multi-segment waveform, triggered by the
"Create" or "Create and Load" function.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe on page 760
Create/Create and Load
●
"Create"
Creates a multi-segment waveform using the current entries in the Segment Table.
●
"Create and Load"
Creates a multi-segment waveform and loads it in the ARB generator.
The R&S SMBV100B stores the multi-carrier waveform as file with filename as speci-
fied with parameter Output file.
Depending on the configuration of the multi-carrier waveform, calculation takes some
time. Use the "Abort" function, to interrupt the calculation.
Remote command:
To define the configuration file (*.inf_mswv) used by the calculation of the output file:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
Or [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
To define the filename of the output waveform file (*.wv):
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
3.7.3.2 Segment Table
Access:
1. Select "Baseband > ARB > General > Multi Segment".
2. In the "ARB: Multi Segment > General" dialog, select an existing list.
3. Select "ARB: Multi Segment > Segment Table".
4. Select "Append" to add existing waveform segments.
Generating Multi-Segment Waveform Files
To Next Page
Loading...
