Rohde & Schwarz SMBV100B - Page 203

Configuring the Internal Baseband Source
R&S
®
SMBV100B
201User Manual 1178.4460.02 ─ 03
● "Sequence Table" contains more than one segment.
Settings:
New List...................................................................................................................... 201
Load List......................................................................................................................201
Save List/Save List As................................................................................................ 201
Sequencing List...........................................................................................................201
Comment.....................................................................................................................201
Output file....................................................................................................................202
Create/Create and Load..............................................................................................202
New List
Accesses the standard "Create Multi Segment Waveform List" function to enter the
name of the new file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:SELect on page 761
Load List
Accesses the standard "File Select" function to select the configuration file to be edi-
ted.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CATalog? on page 759
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:SELect on page 761
Save List/Save List As...
Saves the current entries of the Segment Table in a configuration list (file), including
the level mode, clock mode, segment marker mode, and output filename settings.
See also Chapter 3.7.2.3, "File Concept", on page 194.
Consider also the following remote control commands:
●
To define the configuration file (*.inf_mswv) used by the calculation of the output
file:
– [:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
– [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
●
To define the filename of the output waveform file (*.wv):
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
n.a.
Sequencing List
Accesses the dedicated dialog for configuring the associated play lists, see Chap-
ter 3.7.3.4, "Multi-Segment Waveform Sequencing", on page 207.
This function is enabled, if a multi segment file is created or created and loaded.
Remote command:
n.a.
Comment
Adds a comment to the composed multi-segment file.
Generating Multi-Segment Waveform Files