Rohde & Schwarz SMBV100B - Generating Signals According to Digital Standards

Configuring the Internal Baseband Source
R&S
®
SMBV100B
87User Manual 1178.4460.02 ─ 03
The "Baseband" block comprises all functions and settings concerning the base-
band signal. These include all generation modes, as described in the Chapter 3.1,
"Overview of the Signal Generation Modes", on page 85.
2. The signal generation is not started immediately.
To activate the baseband generator: in the block diagram, select the "Baseband"
block and set "Baseband > On".
Note: The internal baseband generator ("Baseband" block) and the external digital
baseband input ("BB Input") cannot be activated simultaneously. They deactivate
each other.
A short designation indicates the digital standard or modulation currently selected.
For information, see:
● Chapter 3.5, "Generating Custom Digital Modulated Signals", on page 116
● Chapter 3.6, "Using the Arbitrary Waveform Generator (ARB)", on page 145
● Chapter 3.9, "Generating Multi-Carrier Continuous Wave Signal", on page 241
● The description of the digital standards
● Chapter 3.10, "Shifting and Boosting the Baseband Signal", on page 250
3.3 Generating Signals According to Digital Standards
The R&S SMBV100B generates digital signals in accordance with the specifications of
the main communication and radio standards only if the corresponding firmware
options are installed.
GSM/EDGE, EDGE Evolution
This digital standard requires an instrument equipped with the GSM/EDGE and EDGE
Evolution options R&S SMBVB-K40/-K41.
The GSM/EDGE, EDGE Evolution options provide functionality to generate signals in
accordance with the GSM/EDGE standard, based on the GMSK and 8PSK modulation,
and in accordance with the EDGE Evolution standard with simulation of higher order
modulations.
For details, see the R&S SMBV100B GSM/EDGE user manual.
Bluetooth
®
Enhanced Data Rate/Low Energy
This digital standard requires an instrument equipped with the options Bluetooth
®
Enhanced Data Rate and Bluetooth
®
5.0 R&S SMBVB-K60/-K117.
The Bluetooth
®
options provides functionality to generate signals in accordance with
the Bluetooth Specification 5.0+EDR and the latest Bluetooth Low Energy specifica-
tion.
For details, see the R&S SMBV100B Bluetooth EDR user manual.
Generating Signals According to Digital Standards