Rohde & Schwarz SMBV100B - Global Connector Settings

General Instrument Functions
R&S
®
SMBV100B
519User Manual 1178.4460.02 ─ 03
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
10.2.3.2 Global Connector Settings
Each of the "Trigger In", "Marker" and "Clock" dialogs as well as the "Trigger Marker
Clock" dialog provides a quick access to the related connector settings.
For more information, refer to the description R&S SMBV100B user manual, section
"Global Connector Settings".
10.2.4 RF Connectors Settings
Access:
1. Perform one of the following:
● In the "RF block", select "RF > RF Freqeuncy > Connectors".
● In the "control signal block" next to the RF block, select T/E/L/P/V status LEDs.
The "RF Connectors" dialog gives an overview of the mapping of the logical signals
to the connectors; the displayed connectors depend on the installed options. The
signal assignment to the dedicated RF connectors, for example LO In/Out or Inst
Trig, is fixed.
Selecting a connector name accesses directly the related connector settings.
2. Select the "Signal" name to access the dialog with respective settings.
Configuring the Global Connectors