Remote Control Commands
R&S
®
SMBV100B
703User Manual 1178.4460.02 ─ 03
Manual operation: See "Total Deviation" on page 355
[:SOURce<hw>]:PM:RATio <Ratio>
Sets the deviation ratio (path2 to path1) in percent.
Parameters:
<Ratio> float
Range: 0 to 100
Increment: 0.01
*RST: 100
Example: See Example "Performing phase modulation" on page 699.
Manual operation: See "Ratio Path2/Path1" on page 355
[:SOURce<hw>]:PM:SENSitivity?
Queries the sensitivity of the externally applied signal for phase modulation.
The returned value reports the sensitivity in RAD/V. It is assigned to the voltage value
for full modulation of the input.
Return values:
<Sensitivity> float
Example: See Example "Performing phase modulation" on page 699.
Usage: Query only
[:SOURce]:PM<ch>[:DEViation] <Deviation>
Sets the modulation deviation of the phase modulation in RAD.
Parameters:
<Deviation> float
The maximal deviation depends on the RF frequency and the
selected modulation mode (see data sheet).
Range: 0 to max
Increment: 1
*RST: 1
Default unit: RAD
Example: See Example "Performing phase modulation" on page 699.
Manual operation: See "Deviation" on page 354
12.16.3.5 SOURce:PULM Subsystem
Option: see Chapter 6.11.1, "Required Options", on page 346.
SOURce Subsystem
To Next Page
Loading...
