Rohde & Schwarz SMBV100B - Source:bb Subsystem

Remote Control Commands
R&S
®
SMBV100B
709User Manual 1178.4460.02 ─ 03
INVerted
Suppresses the RF signal during the pulse.
*RST: NORMal
Example: See Example "Perform pulse modulation" on page 704.
Manual operation: See "Polarity" on page 364
[:SOURce<hw>]:PULM:IMPedance <Impedance>
Sets the impedance for the external pulse trigger and pulse modulation input.
Parameters:
<Impedance> G50 | G10K
*RST: G50
Example: See Example "Perform pulse modulation" on page 704.
Manual operation: See "Impedance" on page 364
12.16.4 SOURce:BB Subsystem
This subsystem contains all commands for digital signal generation. It is divided into
several subsystems which are described separately.
● SOURce:BB Subsystem General Commands...................................................... 709
● SOURce:BB:DM Subsystem.................................................................................712
● SOURce:BB:ARBitrary Subsystem.......................................................................737
● SOURce:BB:MCCW Subsystem...........................................................................779
● SOURce:AWGN Subsystem................................................................................. 795
● SOURce:BB:IMPairment Subsystem....................................................................802
● SOURce:BB:GRAPhics Subsystem......................................................................807
● SOURce:BB:PROGress Subsystem General Commands....................................810
12.16.4.1 SOURce:BB Subsystem General Commands
The following section describes the commands for setting the frequency shift and the
phase offset for the signal at the output of the "Baseband" and "BB Input" blocks.
The following commands are available:
[:SOURce<hw>]:BBIN:FOFFset.......................................................................................710
[:SOURce<hw>]:BB:FOFFset..........................................................................................710
[:SOURce<hw>]:BBIN:POFFset.......................................................................................710
[:SOURce<hw>]:BB:POFFset..........................................................................................710
[:SOURce<hw>]:BB:ROUTe............................................................................................ 710
[:SOURce<hw>]:BBIN:ROUTe.........................................................................................710
[:SOURce<hw>]:BB:POWer:PEAK?.................................................................................711
[:SOURce<hw>]:BB:CFACtor?.........................................................................................711
[:SOURce<hw>]:BB:POWer:RMS?...................................................................................711
SOURce Subsystem