Rohde & Schwarz SMBV100B - Source:phase Subsystem

Remote Control Commands
R&S
®
SMBV100B
866User Manual 1178.4460.02 ─ 03
Manual operation: See "Pulse Output State" on page 362
[:SOURce<hw>]:PGENerator:STATe <State>
Enables the output of the video/sync signal.
If the pulse generator is the current modulation source, activating the pulse modulation
automatically activates the signal output and the pulse generator.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Using pulse generator as source for pulse modu-
lation" on page 865.
12.16.14 SOURce:PHASe Subsystem
This subsystem contains the commands for adjusting the phase of the RF output signal
relative to a reference signal of the same frequency.
Example: Programming Example
// change the phase relative to the current phase
SOURce1:PHASe 2 DEG
// adopt the setting as the current phase
SOURce1:PHASe:REFerence
The following commands are available:
[:SOURce<hw>]:PHASe................................................................................................. 866
[:SOURce<hw>]:PHASe:REFerence................................................................................866
[:SOURce<hw>]:PHASe <Phase>
Specifies the phase variation relative to the current phase.
Parameters:
<Phase> float
Range: -36000 to 36000
Increment: 0.1
*RST: 0
Default unit: DEG
Example: See Example "Programming Example" on page 866.
Manual operation: See "Delta Phase" on page 297
[:SOURce<hw>]:PHASe:REFerence
Assigns the value set with command [:SOURce<hw>]:PHASe as the reference
phase.
SOURce Subsystem