Rohde & Schwarz SMBV100B - Test Signal Commands

Remote Control Commands
R&S
®
SMBV100B
746User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:ARBitrary:PRAMp[:STATe] <ArbPramState>
If activated, the burst gate marker signal included in the ARB waveform file is used as
marker signal for the pulse modulator.
Parameters:
<ArbPramState> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce1:BB:ARBitrary:WAVeform:SELect "/var/user/Pulse_PMod_Burst"
SOURce1:BB:ARBitrary:PRAMp:STATe 1
SOURce1:BB:ARBitrary:STATe 1
Options: R&S SMBVB-K22
Manual operation: See "RF Power Ramping with Burst Marker" on page 154
Test Signal Commands
[:SOURce<hw>]:BB:ARBitrary:SIGNal:TYPE.................................................................... 746
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I....................................................................746
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q..................................................................746
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:AMPLitude.......................................... 747
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:FREQuency........................................ 747
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:OFFSet...............................................747
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:SAMPles.............................................748
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency................................................. 748
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe........................................................ 748
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles..................................................... 748
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed............................................. 749
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed...................................749
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed............................................749
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate......................................................... 749
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate...............................................749
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate....................................................... 749
[:SOURce<hw>]:BB:ARBitrary:SIGNal:TYPE <ArbSignalType>
Selects the type of test signal.
Parameters:
<ArbSignalType> SINE | RECT | CIQ
*RST: SINE
Example: See Example "Creating test signals" on page 737.
Manual operation: See "Test Signal Form" on page 154
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I <I>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q <TSig>
Sets the value for the I and Q component of the test signal
SOURce Subsystem