Configuring the Internal Baseband Source
R&S
®
SMBV100B
226User Manual 1178.4460.02 ─ 03
●
Target Crest Factor: determines the Target Crest Factor. A value above the crest
factor of the unclipped multicarrier signal has no effect.
●
Filter cutoff frequency: determines the filter parameter of the final lowpass filter.
When the cutoff frequency is set as half of the output sample rate, a final lowpass
filter improves the spectrum of the clipped multicarrier signal. However, it can also
increase the resulting crest factor.
3.8.3 Multi-Carrier Settings
Access:
► Select "Baseband > ARB > General > Create Multi Carrier".
The "ARB: Multi Carrier" dialog enables direct configuration of the carrier distribu-
tion around the center frequency and adjusting some parameters for improving the
signal characteristics.
The dialog is divided into several tabs. In each case, the current setting is dis-
played in the tab name. The tab "Carrier Table" enables the selection of the wave-
form files to be processed. Use the "Carrier Graph" to visualize the configured sig-
nal.
The remote commands required to define these settings are described in Chap-
ter 12.16.4.3, "SOURce:BB:ARBitrary Subsystem", on page 737.
Settings:
● General Settings................................................................................................... 226
● Carrier Table Settings............................................................................................233
● Carrier Table Assistant..........................................................................................235
● Carrier Graph........................................................................................................ 237
3.8.3.1 General Settings
Access:
► Select "Baseband > ARB > General > Create Multi Carrier".
This tab comprises settings for selecting the output waveform file, enabling the genera-
tion, and the configuration of the carrier distribution.
Generating Multi-Carrier Signals
To Next Page
Loading...
