Rohde & Schwarz SMBV100B - Setting for Handling the Multi-Segment Files and Output File Settings

Configuring the Internal Baseband Source
R&S
®
SMBV100B
200User Manual 1178.4460.02 ─ 03
3. Select "Multi Segment" > "Sequencing List" to access the settings for configuring
a sequencing "Play List" for fast automatic processing of the multi-segment wave-
form.
For a description of the provided settings, refer to Chapter 3.7.3.4, "Multi-Segment
Waveform Sequencing", on page 207.
4. Select "Baseband > ARB > General".
The "Load Waveform" confirms that the current multi-segment file is loaded (file-
name as defined with "Output File").
Note: The provided settings depend on the current waveform.
The "Sequencing List" function for instance requires that:
● Multi segment file is created, i.e. you have executed"Create Output File/
Create and Load Output File".
● "Sequence Table" contains more than one segment.
5. Select "Baseband > ARB > Trigger In (MSW)".
For a description of the provided settings, refer to Chapter 3.7.3.5, "Next Segment
Trigger In Settings", on page 212.
6. Select "Baseband > ARB > General > State > On" to process the configured multi-
segment waveform.
The remote commands required to define these settings are described in Chap-
ter 12.16.4.3, "SOURce:BB:ARBitrary Subsystem", on page 737.
● Setting for Handling the Multi-Segment Files and Output File Settings................ 200
● Segment Table...................................................................................................... 202
● Level / Clock / Marker Settings............................................................................. 205
● Multi-Segment Waveform Sequencing..................................................................207
● Next Segment Trigger In Settings......................................................................... 212
3.7.3.1 Setting for Handling the Multi-Segment Files and Output File Settings
Access:
1. Select "Baseband > ARB > General > Create Multi Segment".
The "General" tab comprises standard functions for file handling, like selecting and
loading of files, or determining the output filename.
2. Perform one of the following:
● Select "New List" to create a multi-segment waveform file
● Select "Load List" to load an existing one
3. Add a comment and select "Output File" to define the filename the multi-segment
waveform is created at.
Note: The provided settings depend on the current waveform.
The "Sequencing List" function for instance requires that:
● Multi segment file is created, i.e. you have executed"Create Output File/
Create and Load Output File".
Generating Multi-Segment Waveform Files