Rohde & Schwarz SMBV100B - Clock Frequency; Create Multi Segment; Waveform Info

Configuring the Internal Baseband Source
R&S
®
SMBV100B
153User Manual 1178.4460.02 ─ 03
The waveform files are files with predefined file extension *.wv. When a file is
selected, the dialog displays short information about the selected waveform.
Enable the ARB generator ("ARB > State > On") to trigger the instrument to load and
process the selected waveform file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WAVeform:SELect on page 750
Waveform Info
Opens a dialog with detailed information about the currently selected waveform. The
display depends on whether the selected waveform file is a multi-segment one or not.
All parameters are read-only.
Remote command:
For non-multi segment waveform files, use the Tag commands (see Chapter 3.6.5,
"Tags for Waveforms, Data and Control Lists", on page 177).
Clock Frequency
Displays or sets the ARB output clock rate.
The value of this parameter is set to the clock rate defined in the loaded waveform file
({CLOCK} tag). The value can be changed afterwards.
Note: The clock frequency must match the value of the externally applied clock source.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CLOCk on page 753
Create Multi Segment
Accesses the dialog for creating multi-segment waveforms (see Chapter 3.7, "Generat-
ing Multi-Segment Waveform Files", on page 193).
Using the Arbitrary Waveform Generator (ARB)