Rohde & Schwarz SMBV100B - Marker Settings

Remote Control Commands
R&S
®
SMBV100B
793User Manual 1178.4460.02 ─ 03
Manual operation: See "External / Trigger Inhibit" on page 112
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode. For detailed description of the trigger modes, refer to "Impact
of the Trigger Modes on the Signal Generation" on page 97.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST: AUTO
Example: See "Programming Examples" on page 779
Manual operation: See "Mode" on page 110
Marker Settings
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE.................................................793
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime.............................................. 793
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime.............................................793
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern.............................................. 794
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider.................................... 794
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?............................794
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay.................................................794
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE <Mode>
Defines the signal for the selected marker output. For detailed description of the regu-
lar marker modes, refer to "Marker Modes" on page 94.
Parameters:
<Mode> RESTart | PULSe | PATTern | RATio
*RST: RESTart
Example: See "Programming Examples" on page 779
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime <OnTime>
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime <OffTime>
Sets the number of samples in the off period of the corresponding marker signal.
Parameters:
<OffTime> integer
Range: 1 to 16777215
*RST: 1
Example: see "Programming Examples" on page 779
Manual operation: See "Marker Mode" on page 114
SOURce Subsystem