File and Data Management
R&S
®
SMBV100B
499User Manual 1178.4460.02 ─ 03
3. Enable "SMB (Samba)"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 10.5,
"Using the Security Settings", on page 535.
5. Select "Accept".
To enable file transfer via USB
1. Select "System Config > Setup > Security > Security > General"
2. Enable "USB Storage"
3. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 10.5,
"Using the Security Settings", on page 535.
4. Select "Accept".
9.9.2 Accessing the File System of the R&S SMBV100B Via ftp
If the R&S SMBV100B is connected to a LAN, you can use file transfer protocol (ftp) to
access the file system and to transfer files from and to the instrument.
For information on how to set up a LAN connection, refer to:
●
Chapter 2.1.4, "Setting Up a Network (LAN) Connection", on page 37
●
Chapter 11, "Network Operation and Remote Control", on page 550
To access the file system via ftp
We assume that the instrument and the remote PC are connected to a LAN.
1. Enable file transfer via ftp
2. Enable write permission on the file system
3. On the remote PC, start the Windows Explorer.
4. In the address field, enter ftp://<"IP Address" of the Instrument>, e.g.
ftp://10.124.0.166.
Tip: The R&S SMBV100B indicates its IP address on the block diagram.
A log-on dialog opens and requests a password.
The default user name and password is instrument.
Tip:
Default password
The FTP and SAMBA file access use the user "instrument" with default password
"instrument".
We recommend that you change this password in the "Setup > Security > Pass-
word Management > Change User Password" dialog before connecting the instru-
ment to the network.
How to Transfer Files from and to the Instrument
To Next Page
Loading...
