Getting Started
R&S
®
SMBV100B
51User Manual 1178.4460.02 ─ 03
Non-Volatile Memory
Option: R&S SMBVB-B80
Slot for removable mass storage.
USB/USB In
●
Female USB type A connector, to connect devices like a keyboard, a mouse, a
memory stick, or the R&S NRP-Z3/Z4 cable for the R&S NRP power sensors
●
Female USB In connector (USB type B), for example for remote control.
See also Chapter 2.1.3, "Connecting USB Devices", on page 36.
LAN
The LAN interface can be used to connect the R&S SMBV100B to a local network for
remote control, remote operation, and data transfer.
For details, see Chapter 2.1.4, "Setting Up a Network (LAN) Connection", on page 37.
AC supply and power switch
The AC power supply connector and the main power switch are located in a unit on the
rear panel of the instrument.
Main power switch function:
●
Position 1: The instrument is in operation.
●
Position 0: The entire instrument is disconnected from the AC power supply.
For details, refer to Chapter 2.1.1.6, "Turning the Instrument On and Off", on page 32.
2.3 Trying Out the Instrument
This chapter introduces the most important functions and settings of the
R&S SMBV100B step by step. The complete description of the functionality and its
usage is given in the R&S SMBV100B user manual. Basic instrument operation is
described in Chapter 2.5, "Instrument Control", on page 73.
Prerequisites
●
The instrument is set up, connected to the power supply, and started up as descri-
bed in Chapter 2.1, "Preparing for Use", on page 28.
For the first signal generation tasks, you use the internal baseband and reference sig-
nal, so you do not need any additional signal source. More complex signal generation
tasks, however, require an instrument equipped with additional options and/or external
signals. Each task description lists its prerequisites.
The screenshots in this description show a fully equipped instrument. Consider that,
the block diagram displayed on your particular instrument can differ from the one used
in the example.
The instrument is manually operated via the touchscreen. Try out the following:
Trying Out the Instrument
To Next Page
Loading...
