Rohde & Schwarz SMBV100B - Generating Multi-Segment Waveform Files

Configuring the Internal Baseband Source
R&S
®
SMBV100B
193User Manual 1178.4460.02 ─ 03
Manual operation: See "Select Ramp to Edit" on page 132
3.7 Generating Multi-Segment Waveform Files
Modern chip technologies implement several communication standards within one chip
and rise special verification and test requirements. To fulfill the requirements of these
test systems and to enable rapid alternation between different waveforms with differing
test signals, the R&S SMBV100B provides the functionality to generate multi-segment
waveform files.
This section introduces the concept of the multi-segment waveform files, together with
description of the provided settings and some typical configuration examples.
3.7.1 Required Options
See Chapter 3.6.1, "Required Options", on page 145.
Multi-segment waveform files require the corresponding Digital Standard options
(R&S SMBV100B-K2xx) of all included standards.
3.7.2 About the Multi-Segment Waveforms
A multi-segment waveform is a composed signal that contains several multiple inde-
pendent waveforms called segments. Each segment is an independent waveform that
can be output with its own marker and clock settings.
The Figure 3-23 shows the principle of building a multi-segment waveform.
Figure 3-23: ARB Multi-Segment Waveform Concept
Generating Multi-Segment Waveform Files