Rohde & Schwarz SMBV100B - Internal Baseband Source (Baseband Block)

Getting Started
R&S
®
SMBV100B
71User Manual 1178.4460.02 ─ 03
The cross-reference between the installed options and the displayed settings
The Table 2-10 is an excerpt of the available options and lists only the options required
to display a functional block in the block diagram. The information assumes
R&S SMBV100B base unit.
For exact information on the available options, and on the minimum requirements and
the interdependencies between the provided options, refer to the R&S SMBV100B
data sheet.
Table 2-10: Required options per functional block (excerpt)
Functional block Required option
"Baseband" -
"BB Input"
"AWGN" R&S SMBVB-K62
"I/Q Stream Mapper" -
"I/Q Mod" -
"I/Q Analog" -
"RF" R&S SMBVB-B103/-KB106
2.4.3 Internal Baseband Source ("Baseband" Block)
The "Baseband" block represents the source of the baseband signals (basebands).
This functional block is the access point to:
●
The internal baseband generator
The baseband generator contains modules for real time signal generation (Custom
Digital Modulation) and an arbitrary waveform generator (ARB).
●
The available digital standards
Generation of digital signals in accordance with the supported standards requires
additional software options. For example, option R&S SMBVB-K55 generates sig-
nals according to the EUTRA/LTE standard.
System Overview