Rohde & Schwarz SMBV100B - Rectangular Test Signal

Configuring the Internal Baseband Source
R&S
®
SMBV100B
156User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles on page 748
Phase Offset Q
Enters the phase offset of the sine-wave signal on the Q channel relative to the sine-
wave signal on the I channel.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe on page 748
Generate Signal File
Generates a signal and saves it as a waveform file on the hard disk. Use the standard
"File Select" function to store this file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed on page 749
Generate Signal RAM
Generates a signal and uses it as output straight away. The instrument stores the file
with a predefined name.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate on page 749
3.6.3.3 Rectangular Test Signal
Access:
1. Select "Baseband > ARB > General > Create Test Signal > Rect".
2. Select "Create Test Signal".
Using the Arbitrary Waveform Generator (ARB)