General Instrument Functions
R&S
®
SMBV100B
543User Manual 1178.4460.02 ─ 03
Enabling a locked user interface for manual operation
To unlock the user interface for manual operation, use one of the following:
●
On the instrument's keypad or external keyboard, press any key.
The instrument prompts you to enter the security password for unlocking.
Note: The character of the first key you pressed is immediately added in the input
field. Delete the entry before inserting the password.
Enter the security password 123456.
●
In remote control mode, send the command SYST:ULOC ENABled to release all
locks at once.
Alternatively:
– Send the command SYST:KLOC OFF to unlock the keyboard and touchscreen
– Send the command SYST:DLOC OFF to release all locks.
Via remote control, there is no password required.
Remote command:
:SYSTem:ULOCk on page 895
:SYSTem:DLOCk on page 895
:SYSTem:KLOCk on page 896
10.5.3 Configuring LAN Services
Access:
► Select "System Config > Setup > Security > Security > LAN Services".
In the "LAN Services" dialog, you can individually enable or disable the supported
LAN interface services.
Using the Security Settings
To Next Page
Loading...
