Rohde & Schwarz SMBV100B - List Mode Data Settings

Configuring the RF Signal
R&S
®
SMBV100B
338User Manual 1178.4460.02 ─ 03
"Positive"
The rising edge of the trigger signal triggers the instrument.
"Negative"
The falling edge of the trigger signal triggers the instrument.
Remote command:
[:SOURce]:INPut:TRIGger:SLOPe on page 830
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
Reset
Resets the list to the starting point.
Remote command:
[:SOURce<hw>]:LIST:RESet on page 860
Execute Single
Manually starts list processing in "Single" mode.
Remote command:
[:SOURce<hw>]:LIST:TRIGger:EXECute on page 857
6.10.6.2 List Mode Data Settings
Access:
1. Select "RF" > "Sweep/List" > "List mode".
2. Select "List Mode Data".
This dialog contains the parameters required for creating and editing lists, activat-
ing the learning function and selecting the list processing mode.
Settings
List Mode Data ...........................................................................................................338
Edit List Mode Data ....................................................................................................339
List Range from/to ......................................................................................................339
List Mode Data
Accesses the standard "Select List" dialog for selecting, creating and editing a list file.
The currently loaded file is indicated.
Varying the RF Signal in List or Sweep Mode