General Instrument Functions
R&S
®
SMBV100B
547User Manual 1178.4460.02 ─ 03
Change Password ← User Password
Changes the user password accordingly.
Security Password
Access: select "System Config > Setup > Security > Security > Password Management
> Security Password".
Enables you to change and confirm the security password.
Old Password ← Security Password
Enters the currently used security password. The default password is '123456'.
Note: We recommend that you change the default password before connecting the
instrument to a network.
The security password is required when changing the status of the USB and LAN inter-
face.
New Password ← Security Password
Enters the new security password.
The security password can contain decimal characters only.
Confirm Password ← Security Password
Confirms the new security password by repeating.
Note: The new password is not assigned until you select Change Password button.
Change Password ← Security Password
Changes the password accordingly.
10.6 Undoing or Restoring Actions
"Undo" is a function that removes the effect of the last action on the instrument and
reverts it to an older state. Conversely, "Redo" restores a previously undone action.
You can "Undo/Redo" actions according to two criteria:
●
Step by step
Gradually undo/redo the actions in reverse order as previously performed.
Depending on the available memory the "Undo/Redo" steps may restore all
actions.
●
Multiple steps at once
Select any specific action in the history list to "Undo/Redo" multiple actions in a sin-
gle step.
Note: This mode requires a system restoration file on the instrument.
Undoing or Restoring Actions
To Next Page
Loading...
