Rohde & Schwarz SMBV100B - Page 796

Remote Control Commands
R&S
®
SMBV100B
794User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern <Pattern>, <BitCount>
Defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern> numeric
*RST: #H2
<BitCount> integer
0 = marker off, 1 = marker on
Range: 1 to 64
*RST: 2
Example: See "Programming Examples" on page 779.
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider
<Divider>
Sets the divider for pulse marker mode.
Parameters:
<Divider> integer
Range: 2 to 1024
*RST: 2
Example: See "Programming Examples" on page 779
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal.
Return values:
<Frequency> float
Increment: 1E-3
Example: see "Programming Examples" on page 779
Usage: Query only
Manual operation: See "Marker Mode" on page 114
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay <Delay>
Defines the delay between the signal on the marker outputs and the start of the sig-
nals, expressed as number of samples.
SOURce Subsystem