Rohde & Schwarz SMBV100B - Page 236

Configuring the Internal Baseband Source
R&S
®
SMBV100B
234User Manual 1178.4460.02 ─ 03
Number of Carriers
Defines the number of carriers of the multi-carrier waveform.
This parameter is identical to the one in the "General Setting" section.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier:COUNt on page 763
No
Indicates the carrier index ranging from 0 to (number of carriers -1).
Remote command:
Individual carriers are set by the index at the keyword CARR
State
Switches On/Off a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:STATe on page 767
Carrier Freq [MHz]
Sets the carrier frequency.
Note: The carrier frequency can only be set in "Arbitrary Carrier frequency" mode. For
"Equidistant Carrier Spacing", the carrier spacing is determined automatically.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FREQuency
on page 768
Gain
Sets the gain of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:POWer on page 768
Phase
Sets the starting phase of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:PHASe on page 768
Delay
Sets the starting delay of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:DELay on page 769
File
Accesses the standard "File Select" function for selecting the input file. The input file
contains the I/Q signal that is modulated onto the carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FILE on page 769
Generating Multi-Carrier Signals