Remote Control Commands
R&S
®
SMBV100B
800User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:AWGN:BRATe <BRate>
Sets the bit rate used for calculation of bit energy to noise power ratio.
Valid units are bps, kbps and mabps as well as b/s, kb/s and mab/s.
Parameters:
<BRate> float
Range: 400 to depends on the installed options
Increment: 0.001
*RST: 100000
Example: see Example "Generating an additive noise signal" on page 796
Manual operation: See "Bit Rate" on page 263
[:SOURce<hw>]:AWGN:CNRatio
<CnRatio>
Sets the carrier/interferer ratio.
Parameters:
<CnRatio> float
Range: -50 to 45
Increment: 0.01
*RST: 0
Example: See Example "Generating an additive noise signal" on page 796
Manual operation: See "Carrier/Noise Ratio, Signal/Noise Ratio" on page 263
[:SOURce<hw>]:AWGN:ENRatio <EnRatio>
Sets the ratio of bit energy to noise power density.
Parameters:
<EnRatio> float
Range: -50 to depends on the installed options
Increment: 0.01
*RST: 15.84
Default unit: dB
Example: See Example "Generating an additive noise signal" on page 796
Manual operation: See "E
b
/N
0
" on page 264
[:SOURce<hw>]:AWGN:POWer:CARRier <Carrier>
Sets the carrier power.
Parameters:
<Carrier> float
Increment: 0.01
*RST: 0
SOURce Subsystem
To Next Page
Loading...
