Remote Control Commands
R&S
®
SMBV100B
777User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern...........................................777
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider.................................778
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?........................ 778
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay............................................. 778
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:MODE <Mode>
Defines the signal for the selected marker output.
For detailed description of the regular marker modes, refer to "Marker Modes"
on page 94.
Parameters:
<Mode> UNCHanged | RESTart | PULSe | PATTern | RATio
UNCHanged
A marker signal as defined in the waveform file (tag 'marker
mode x') is generated.
*RST: UNCHanged
Example: see Example "Managing waveform files" on page 738
Manual operation: See "Marker Mode" on page 159
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:ONTime <OnTime>
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:OFFTime <OffTime>
Sets the number of samples in the ON and OFF periods.
Parameters:
<OffTime> integer
Range: 1 to 14913079
*RST: 1
Example: see Example "Managing waveform files" on page 738
Manual operation: See "Marker Mode" on page 159
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern <Pattern>,
<BitCount>
Defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern> numeric
*RST: #H2
<BitCount> integer
0 = marker off, 1 = marker on
Range: 1 to 64
*RST: 2
Example: See Example "Managing waveform files" on page 738.
SOURce Subsystem
To Next Page
Loading...
