Multi-Instrument Setups
R&S
®
SMBV100B
452User Manual 1178.4460.02 ─ 03
Name / IP Address
Displays/sets the IP address or hostname of the connected external instrument.
Remote command:
:SCONfiguration:EXTernal:REMote:ADD on page 672
:SCONfiguration:EXTernal:DIGital:REMote:INFO? on page 674
:SCONfiguration:EXTernal:IQOutput:REMote:INFO? on page 674
RF Path
In a two-path instrument, determines the RF output to be used.
Remote command:
:SCONfiguration:EXTernal:REMote:ADD on page 672
:SCONfiguration:EXTernal:DIGital:REMote:INFO? on page 674
:SCONfiguration:EXTernal:IQOutput:REMote:INFO? on page 674
Initialization Sequence
Accesses the standard "File Select" dialog for loading an existing initialization file
(extension *.iec).
When you establish the connection to an external instrument, i.e. Remote Connection
Status is active, the R&S SMBV100B performs the following:
●
Sends the command :DEVice:PRESet
●
Sends the content of the initialization sequence file to reconfigure the external
instrument
If necessary, perform further settings and configuration of the external instruments.
Remote command:
:SCONfiguration:EXTernal:REMote:INITialization:CATalog?
on page 675
:SCONfiguration:EXTernal:DIGital:REMote:INITialization:FILE
on page 675
:SCONfiguration:EXTernal:IQOutput:REMote:INITialization:FILE
on page 675
Remove Initialization Sequence
Deletes the loaded sequence.
Apply
Confirms the settings and displays the external instrument in the "External RF and I/Q"
dialog.
Remote command:
:SCONfiguration:EXTernal:DIGital:REMote:ISELect on page 674
:SCONfiguration:EXTernal:IQOutput:REMote:ISELect on page 674
Apply and Connect
Confirms the settings and triggers the connection establishment. In the connected
instruments, the status of this active remote connection is displayed by the "Remote"
indication.
System Configuration Settings
To Next Page
Loading...
