Rohde & Schwarz SMBV100B - Page 793

Remote Control Commands
R&S
®
SMBV100B
791User Manual 1178.4460.02 ─ 03
Usage: Event
Manual operation: See "Arm" on page 111
[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute
Executes a trigger.
Example: See "Programming Examples" on page 779
Usage: Event
Manual operation: See "Execute Trigger" on page 111
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut
<Output>
Enables signal output synchronous to the trigger event.
Parameters:
<Output> 0 | 1 | OFF | ON
*RST: 1
Example: See "Programming Examples" on page 779
Manual operation: See "Sync. Output to External Trigger/Sync. Output to Trigger"
on page 112
[:SOURce<hw>]:BB:MCCW:TRIGger:RMODe?
Queries the status of signal generation for all trigger mode, if multi-carrier CW genera-
tion is on.
Return values:
<RMode> STOP | RUN
Example: See "Programming Examples" on page 779
Usage: Query only
Manual operation: See "Running/Stopped" on page 111
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth <SLength>
Defines the length of the signal sequence to be output in the "Single" trigger mode.
Parameters:
<SLength> integer
Range: 1 to 1000
*RST: 1
Default unit: samples
Example: See "Programming Examples" on page 779
Manual operation: See "Signal Duration" on page 111
SOURce Subsystem