Rohde & Schwarz SMBV100B - Page 247

Configuring the Internal Baseband Source
R&S
®
SMBV100B
245User Manual 1178.4460.02 ─ 03
Settings:
Table Setup Assistant..................................................................................................245
└ Carrier Start/Stop..........................................................................................245
└ Carrier State..................................................................................................245
└ Power Start................................................................................................... 245
└ Power Step................................................................................................... 246
└ Phase Start................................................................................................... 246
└ Phase Step................................................................................................... 246
└ Accept...........................................................................................................246
Carrier Table................................................................................................................246
Table Setup Assistant
Enables joint configuration of selectable range of carriers.
Carrier Start/Stop ← Table Setup Assistant
Defines the start/stop index of the carrier range to which the following settings are
intended to apply.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt on page 790
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP on page 790
Carrier State ← Table Setup Assistant
Switches the carriers in the carrier range on/off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe on page 790
Power Start ← Table Setup Assistant
Sets the power of the starting carrier.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt] on page 789
Generating Multi-Carrier Continuous Wave Signal