Rohde & Schwarz SMBV100B - Page 777

Remote Control Commands
R&S
®
SMBV100B
775User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute
Executes an internal trigger event.
Example: See Example "Managing waveform files" on page 738
Usage: Event
Manual operation: See "Execute Trigger" on page 111
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:SYNChronize:OUTPut
<Output>
Enables signal output synchronous to the trigger event.
Parameters:
<Output> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Managing waveform files" on page 738
Manual operation: See "Sync. Output to External Trigger/Sync. Output to Trigger"
on page 112
[:SOURce<hw>]:BB:ARBitrary:TRIGger:DELay:UNIT <TrigDelUnit>
Sets the units the trigger delay is expressed in.
Parameters:
<TrigDelUnit> SAMPle | TIME
*RST: SAMPle
Example: See Example "Specifying delay and inhibit values in time units"
on page 739
Manual operation: See "(External) Delay Unit" on page 112
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:DELay <Delay>
Specifies the trigger delay.
Parameters:
<Delay> float
Range: 0 to 2147483647
Increment: 0.01
*RST: 0
Example: see Example "Managing waveform files" on page 738
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 113
SOURce Subsystem