Rohde & Schwarz SMBV100B - Page 680

Remote Control Commands
R&S
®
SMBV100B
678User Manual 1178.4460.02 ─ 03
[:SOURce]:INPut:USER:PULM:LEVel...............................................................................680
[:SOURce]:INPut:USER:CLOCk:IMPedance..................................................................... 680
[:SOURce]:INPut:USER:TRIGger:IMPedance................................................................... 680
[:SOURce]:INPut:USER:CLOCk:SLOPe...........................................................................681
[:SOURce]:INPut:USER:TRIGger:SLOPe......................................................................... 681
[:SOURce]:INPut:USER<ch>:DIRection <Direction>
:OUTPut:USER<ch>:DIRection <Direction>
Determines whether the connector is used as an input or an output.
Suffix:
USER<ch>
.
1 to 5
Parameters:
<Direction> INPut | OUTPut | UNUSed
UNUSed = the connector is not defined
Example: See Example "Global connectors settings configuration"
on page 677.
Manual operation: See "User x Connector Direction" on page 521
[:SOURce]:INPut:USER<ch>:SIGNal <Signal>
Determines the control signal that is input at the selected connector.
To define the connector direction, use the command [:SOURce]:INPut:USER<ch>:
DIRection.
Suffix:
USER<ch>
.
1 to 5
Parameters:
<Signal> TRIG1 | CLOCK1 | NSEGM1 | NONE | SYNCIN | BERDATIN |
BERCLKIN | BERDATENIN | BERRESTIN
TRIG1 = Global Trigger
CLOCK1 = Global Clock
NSEGM1 = Global Next Segment
SYNCIN = Baseband Sync In
BERDATIN|BERCLKIN|BERDATENIN|BERRESTIN = BER
Data, Clock, Data Enable and Restart
NONE = none
Example: See Example "Global connectors settings configuration"
on page 677.
Options: BERDATIN|BERCLKIN|BERDATENIN|BERRESTIN require
R&S SMBVB-K80
Manual operation: See "Signal" on page 522
SOURce Subsystem