Rohde & Schwarz SMBV100B - Page 835

Remote Control Commands
R&S
®
SMBV100B
833User Manual 1178.4460.02 ─ 03
Example: Enabling and configuring the analog output
SCONfiguration:OUTPut:MAPPing:IQOutput1:STReam1:STATe 1
SOURce1:IQ:OUTPut:ANALog:PRESet
SOURce1:IQ:OUTPut:ANALog:TYPE DIFF
SOURce1:IQ:OUTPut:ANALog:MODE VAR
SOURce1:IQ:OUTPut:LEVel 2
SOURce1:IQ:OUTPut:ANALog:BIAS:COUPling:STATe 1
SOURce1:IQ:OUTPut:ANALog:BIAS:I 1
SOURce1:IQ:OUTPut:ANALog:BIAS:Q?
// 1
SOURce1:IQ:OUTPut:ANALog:OFFSet:I 2
SOURce1:IQ:OUTPut:ANALog:OFFSet:Q 2.5
SOURce1:IQ:OUTPut:ANALog:STATe 1
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe.....................................................................833
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:PRESet.................................................................833
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:CATalog?................................................. 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:STORe.................................................... 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:LOAD...................................................... 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:DELete.................................................... 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE....................................................................835
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:MODE...................................................................835
[:SOURce<hw>]:IQ:OUTPut:LEVel...................................................................................835
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe]..........................................836
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:I................................................................... 836
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q................................................................. 836
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:I............................................................... 836
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:Q..............................................................836
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:POWer:DATTenuation.............................................837
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe <State>
Activates the specified analog I/Q output.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:ANALog:STATe ON
Activates the output of the analog I/Q signal on the [I/Q Out 1]
connectors.
Manual operation: See "State" on page 467
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:PRESet
Sets the default settings (*RST values specified for the commands).
Not affected are:
●
The state set with the command [:SOURce<hw>]:IQ:OUTPut:ANALog:STATe.
SOURce Subsystem