Rohde & Schwarz SMBV100B - Page 469

Multi-Instrument Setups
R&S
®
SMBV100B
467User Manual 1178.4460.02 ─ 03
RF Envelope............................................................................................................... 468
Show Connector..........................................................................................................468
I/Q Output Type...........................................................................................................468
Mode........................................................................................................................... 468
Digital Attenuation.......................................................................................................469
I/Q Level Vp EMF........................................................................................................469
Couple I/Q Bias...........................................................................................................469
Bias (EMF).................................................................................................................. 469
Offset (EMF)................................................................................................................470
State
Enables/disables the analog I/Q output.
Note: By default, these output connectors are deactivated.
Remote command:
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe on page 833
Set to Default
Calls the default settings. The values of the main parameters are listed in the following
table.
Parameter Value
"State" Not affected by the "Set to Default"
"RF Envelope" Off
"I/Q Output Type"
Depends on "System Configuration > External RF and I/Q > Preset behavior:
Keep connections to external instruments":
●
"Off": Single Ended
●
"On": Not affected by the "Set to Default"
"I/Q Level Vp (EMF)" 1 V
"Bias (EMF)" 0 mV
Remote command:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:PRESet on page 833
Save/Recall
Accesses the "Save/Recall" dialog, that is the standard instrument function for saving
and recalling the complete dialog-related settings in a file. The provided navigation
possibilities in the dialog are self-explanatory.
The filename and the directory, in which the settings are stored, are user-definable; the
file extension is however predefined.
See also Chapter 9, "File and Data Management", on page 471.
Remote command:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:CATalog? on page 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:STORe on page 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:LOAD on page 834
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:DELete on page 834
I/Q Analog Output Settings