Remote Control Commands
R&S
®
SMBV100B
849User Manual 1178.4460.02 ─ 03
You can enable this feature, when you are working with sawtooth shapes in sweep
mode "Single" or "External Single".
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Manual operation: See "Retrace" on page 329
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?
Queries the current status of the LF frequency sweep mode.
Return values:
<State> 0 | 1 | OFF | ON
Example: See Example "Setup an LF sweep" on page 837.
Usage: Query only
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe
<Shape>
Sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example "Setup an LF sweep" on page 837.
Manual operation: See " Shape" on page 329
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing <Spacing>
Selects linear or logarithmic sweep spacing.
Parameters:
<Spacing> LINear | LOGarithmic
*RST: LINear
Example: See Example "Setup an LF sweep" on page 837.
Manual operation: See " Spacing" on page 330
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic
<Logarithmic>
Sets the step width factor for logarithmic sweeps to calculate the frequencies of the
steps.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode",
on page 320
SOURce Subsystem
To Next Page
Loading...
